This occurs when something in the area is emitting a frequency that interferes with the garage door opener remote preventing it from working properly.
Garage door button only works from a couple feet away.
My garage door opener craftsman only allows door to open a half foot then stops.
A garage door opener remote is a convenient tool but when it only works at close distances or stops working altogether it can be frustrating.
Get shopping advice from experts friends and the community.
If pressing the button on your garage door s remote control doesn t work check the batteries first.
Then when activated the door will close as advertised but will only open part way.
It can be quite easy to find the solutions needed to repair your garage opener.
How to fix a garage door that keeps reversing.
Same result with remote or wall switch.
The garage door openers all 3 work at opening the door but are very.
When the garage door opener works intermittently the logic board may be experiencing radio frequency rf interference from nearby sources such as security lights ham radios and some electronics.
This indicates that the springs torsion springs in the case of the photo above are working properly and are not the issue.
3 button compact light gray horizontal buttons.
You push the button to close the garage door.
Your garage door opener stopped operating as it should.
It goes partway down reverses direction and goes back up again.
Genie garage door only moves a few feet and stops and when you push the button again it moves a few inches or a foot down.
This is almost always the result of a.
Locate and eliminate the source of the rf interference.
Left one genie remote garage door opener in rental car.
There are several reasons why your remote might not operate correctly.
It will close when activated but will only open a half foot.
One of the most common causes is rfi or radio frequency interference.
I can disconnect the trolley from the door then open door manually re connect the trolley to the door.
The garage door can be operated manually by disconnecting the garage door opener from the door using the red pull cord.
If the remote works only when held within a few feet of the motor unit rf interference is probably the problem.
If the door is working properly it should be easy to lift by hand.