Garage Door Auto Reverse

You can also call it the contact reversal test pressure test and performance test.

Garage door auto reverse.

You push the button to close the garage door. It goes partway down reverses direction and goes back up again. Refer to the owner s manual to determine which is. In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.

This is almost always the result of a dirty or obstructed safety feature. On the garage door motor there will be two knobs or dials to adjust the opener and the reverse sensor. To decrease the amount of force required to reverse the direction of the garage door turn the knob or screw with a screwdriver counterclockwise one quarter. If the door does not reverse it needs attention immediately.

Adjust the garage door opener mechanism. Eventual outcome of garage door reversing mechanism failure. The photo eyes send an infrared beam across the bottom of your garage door opening if that beam is broken the door will reverse. Another method of testing the auto reverse is to set a 1 1 2 thick piece of wood on the floor in the center of the door s path.

To increase the amount of force turn it clockwise. Home inspectors aim to protect their inspection clients and their clients families from potential perils by testing this safety feature. If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch. When the door contacts the wood it should automatically reverse and return to the open position.

This is a safety feature that has been added to garage door openers to help prevent the door from closing on a car pet or even a child. Re test the auto reverse function and repeat this process until your opener is properly adjusted.